Steering Wheel
 
Before attempting to install any of the raised or flat inserts, you must perform the following steps to ensure a successful installation:

Clean surface with a mild detergent or dishwashing fluid  until you completely remove all grime and oily residues left behind from Armoral or similar products. Clean it regardless of weather you used Armoral, similar products or not.
Failure to do so will result on insert poor adhesion which will follow.

We advise you to install a piece of scotch tape on the surface to test how clean your dash really is. If scotch tape doesn't stick well to your dash surface than that means that further cleaning is necessary. Repeat cleaning procedure until you get a desired result.
Only then you should attempt to install the insert, as you don't want to ruin the adhesive
on your insert.

Tools you will need:


Rubber gloves

* Don't forget to read SUMMER CONDITIONS at the bottom.

 

 

Raised Steering Wheel

 

Safe install between 60° to 80° with 40% to 50% or less humidity  is needed for proper adhesion.
Failure to follow this chart will cause adhesive agent of insert to not stick as it should.

 

  • Clean steering wheel with mild detergent to remove all oil and grime.

  • If Amoral has been previously applied to surface area, further cleaning with stronger detergent will be needed.

  • Align insert over the grooves on your corvette's steering wheel and apply it over.

    After installation insert looks small or out of place, re-alignment will be necessary. Insert will is made to make a perfect fit.
     

Failure to properly clean the area prior to application will result in poor adhesion of insert.
No Free replacements will be made.
 

Allow 3 - 5 days for insert to bond to surface applied

 

SUMMER CONDITIONS

Humidity is no more than water particles in the air, and when the air is saturated with water at a high percentage it will affect not only the effectiveness if the adhesive agent of inserts just as of any other adhesive in general. Not only that but our vehicles run hotter and so does aircraft and even us humans get affected by this natural phenomenon. Therefore in Summer weather mostly this will be a factor in most states in the US.
As humidity can be a factor on a successful installation we must advise you of its effect on any insert installation.

You should only install any insert when the weather is cool and almost no humidity, open your vehicle windows and allow it some time to ventilate throughtout it. Dry  or nearly dry weather would be the perfect climate.
If current weather in your area is carrying high humidity, it would be suggested to wait a few days until humidity percentage lowers to the table on above page.
Heat itself should not be a factor on a successful installation. Humidity is